Granted, you can find other cord-wrangling solutions, like the one I used when I made my cordless workspace, but the rain gutter approach yields impressive results. Sean was nice enough to send in his entire step-by-step, so here goes (everything below was written by Sean):
I recently purchased a new table from IKEA to use as a computer desk. I liked it because it was really long and narrow (78″x23″) and would work perfectly for my wife and I. The problem I ran into was that I didn’t want a bunch of cords and cables hanging down behind the table. Having that would ruin the new ‘clean’ aesthetic I was going for.
So I decided that I needed to find some solution to this cable-clutter problem. I looked at some of the commercial solutions available, but they all either seemed rather expensive, or they didn’t really fit my needs very well. I had remembered reading somewhere about somebody using ordinary vinyl rain gutters in some way (I think they used bungee cords to suspend them from the underside of the table) but I couldn’t really find anything to help me out, so I decided to try to solve it myself.
So I went out and purchased a 10 foot length of vinyl rain gutter and cut it to size. I also bought two end caps and four hangars (used to nail the gutter to the side of your house) and some fasteners. I figured I’d drill up into the bottom of the table, and drive in the lag screws. Then I’d attach them to the threaded hooks with joiner nuts, and hang the rain gutters from those. Easy. Job one, however, was to cut a notch in the gutter so it would fit around the middle leg of the table. Job two was to drill a hole in the hangars to attach the hooks. I also fitted the holes with rubber grommets to cut down on any excess noise they might produce.
After that, it was just a simple matter of doing a dry-fit:
Using the hangars to suspend the length of gutter turned out to be a good idea, since they can slide back and forth, meaning fitting it together was really easy.
Here’s my workspace before I began the project. It’s not really terrible, but it just all felt really pieced together. A flimsy computer desk and a plastic folding table shoved together with all those cables hanging down there. Besides not looking great, it was actually a pain to clean down there, and dust tended to accumulate.
And here’s the after shot:
Notice: no cables hanging down. Everything – my power strips, wireless router, cable modem, usb cables and chargers for two Macbooks is all tucked away nice and clean underneath. The best part is that you can’t even see it unless you’re looking for it.
Nice and tidy. The table is also really great. It came unfinished, and I liked the color and texture so much that I just had a big piece of glass cut to go on top. The only problem is that now my mouse won’t work anymore. Any good tips on making my own (visually appealing) mousepad? I’d appreciate it.
Anyways, the total cost for the project came in at just over $30 and only took about two hours to complete.
Send an email to Adam Pash, the author of this post, at firstname.lastname@example.org.